This was a recoil-operated, water-cooled gun with link-belt ammunition feed, and was significantly less powerful than the USN's 0.50" (12.7 mm) Browning M2 BMG. Like the US and most other nations, the British found small-caliber machine guns like these to be ineffective against modern aircraft. Nonetheless, they were still produced in large numbers during the war with an overall total of 12,500 being built.
A few guns were exported to Japan during the late 1930s where they were designated as the 12 mm/62 "HI" Type. These guns were mostly replaced by the start of the Pacific War by the superior 13 mm and 25 mm Hotchkiss guns. An additional 19 guns were purchased by China.
Actual bore length was 62.5 calibers.
Unless otherwise noted, the data below is for British weapons.
0.5"/62 (12.7 mm) quad mount under construction
Quad 0.50" (12.7 mm) on a destroyer
Quad 0.50" (1.27 cm) MG on HMAS Perth
Single 0.50" (12.7 mm)
Quad 0.5" (12.7 mm) Vickers MG on Mark
See 0.5 Vickers
(see Note 1)
|0.5"/62 (12.7 mm) Mark III
|Ship Class Used On||Britain: Almost all warships in
World War II
|Date Of Design||1926|
|Date In Service||1926|
|Gun Weight||56 lbs. [62 lbs. with filled cooling jacket] (25.4 kg [28.1 kg])|
|Gun Length oa||about 35 in (89 cm)|
|Bore Length||31.25 in (79.4 cm)|
|Rate Of Fire
(see Note 2)
|600 to 700 rounds per minute cyclic
450 rounds per minute cyclic when used with a delay pawl
150 to 200 rounds per minute practical
1) The guns for single and twin mounts were similar to those for the quad mounts but had shoulder rests.
2) Each ammunition drum held 200 rounds, which was enough for about twenty seconds of firing. The four ammunition drums on the quad mounting could be replaced within thirty seconds by a well-trained crew.
|Weight of Complete Round||2.9 oz (0.08 kg)|
|Projectile Types and Weights||Bullet - 1.33 oz (37.6 gm)|
|Bursting Charge||Solid bullet|
|Propellant Charge||2.9 oz (0.08 kg) SC|
|Muzzle Velocity||2,520 fps (768 mps)|
|Approximate Barrel Life||N/A|
|Magazine capacity per gun||About 2,500 rounds|
|Note: Used a 200-round belt carried in a drum. Each loaded drum weighed 60 lbs. (27.2 kg).|
|Elevation||With 1.33 oz (0.37 kg) Bullet|
|Effective Range||800 yards (730 m)|
|Maximum Range||about 5,000 yards (4,570 m)|
|Note: Pre-war calculations determined that a ten second burst with a quad mount, equivalent to 500 rounds, could expect 40 rounds to hit a target. However, this analysis assumed that the target area was entirely within the pattern of spread for the duration of the burst, an assumption that meant that both the layer and the trainer needed to perfectly judge the approach speed of the attacking aircraft and then constantly adjust - by hand - their aiming during those ten seconds, regardless of how their ship rolled and pitched during that time.|
Also some Scarf Ring types
|Weight||Mark I: 1,605 lbs. (728 kg)
Mark I*: 2,200 lbs. (998 kg)
Mark II: 2,888 lbs. (1,310 kg)
Mark III: 2,580 lbs. (1,170 kg)
Mark IV: 1,692 lbs. (772 kg)
Mark V: 1,041 lbs. (472 kg)
Mark VC: N/A
|Elevation||Mark I and Mark I**: -10 / +70
Mark II, Mark II** and Mark III: -10 / +80 degrees
Mark IV: -10 / +70
Mark V and Mark VC: -10 / +70
|Elevation Rate||All except Marks V and VC: Manually
Marks V and VC: 50 degrees per second
|Train Rate||All except Marks V and VC: Manually
Marks V and VC: 72 degrees per second
|Gun recoil||1.25 in (3.2 cm)|
1) The Mark III mounting had a new type of base plate that was more robust and of larger diameter than the previous types. As opportunity offered, the older Mark I and Mark II mountings were modified to bring them into line with the Mark III. These modified mounts were then designated as Mark I* and Mark II* to distinguish them from unmodified mounts.
2) The Mark VC was an American-produced mounting and could also be used for the US 0.50 in (1.27 cm) Browning M2 MG.
3) Large ships usually had four quad mountings, but HMS Ark Royal had eight. Cruisers had two to four and destroyers had two. The twin Mark IV mounting was used mainly on MLs, MMS, some Bangor class minesweepers, and trawlers. The Mark V twin turret was a light weight unit intended for MTBs but also used on a few LCS(M), destroyers and corvettes. It was hydraulically powered and the belt feed ran through hollow inner trunnions. The hydraulic pump was located off the mounting and this was powered from the engine of the MTB.
4) The quad mounting had its barrels slightly misaligned from each other in order to give a "scatter" effect.
07 March 2007 - Benchmark
27 January 2010 - Added picture of single gun
12 February 2012 - Updated to latest template
16 June 2012 - Added picture of HMAS Perth